We can cut
Offer a ready-made solution
Cutting with industrial equipment
By default, we supply the trim and architraves as stand-alone elements without cutting.
This means that the distributor or installer at the installation site has to make these cuts in the trim tabs for the casing to be installed in the door unit.
This is not always possible to do with high quality, because there are no certain conditions for this at the site and the necessary fixation of the part.
In turn, this leads to gaps between the parts.
Additionally, the cut elements of the moldings significantly reduce the time required to install the blocks in the doorway.
Therefore, you need to consider what will be more profitable for you: ordering the cutting from the supplier, or (taking into account the cost of installing the block) making the cutting yourself.
There is also a risk that the installer’s low-quality tool may chip the paint on the products.
In the case of factory cutting, the products are first cut and then painted.
First of all, it is the platband.
Then the batten.
It is still better to cut the additional strips at the place of installation of the block.
Of course, the price will be higher since this is a separate service.
The cost will depend on many factors, so it’s best to contact us with a request.
Yes, it does.
This is an additional operation that takes time and also requires special packaging so that the sharp corners after cutting are not damaged during transportation.